Daktronics PC-2001 Manual do Operador Página 85
- Página / 300
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
If there is only one person available, click Lane Module Test Mode, then turn the
computer monitor so it can be seen from the touchpads and lane modules. Go to the
input devices and active them. The monitor will display the activated device so that
it can be seen from the poolside.
The Scoreboard section contains three buttons for testing the scoreboard:
Cycle On/Off: Click to send an all on signal to the scoreboard approximately
every 3 seconds until deselected.
Show Address: Click to display the driver addresses. The number or letter will
show which output on the driver that digit is plugged into.
Show Digit: Click to confirm the digits are operational and properly plugged at
the time of installation and if the system needs debugging.
Configuring the OmniSport 2000 Pro software is an important for managing swimming
events. To access the Pro configuration, go to Options > Configure on the main application
screen.
This information pertains to both the OmniSport 2000 Pro software and the OmniSport 2000
console. For information on programming the console settings listed in this section, refer to
Section 5: The Console’s Swimming Menus and Settings.
Pool
The Pool tab (Figure 81)
configures the OmniSport
2000 Pro software to the pool
being used.
Select the Number of
Lanes from 1 to 10.
Lane Order is
determined by how
the lane modules are connected to the timing console. If the lane connected to the
console is the first lane, then select Normal option button. If it is not, select Reversed.
Lane Label is used to accommodate pools with lane numbering of 1-10 or 0-9. Select
the appropriate option button.
Lane Length should be set to the length that matches the pool being used, either
25 yards, 25 meters, or 50 meters. The lane length is used with the race length to
calculate how many lengths or touches the timer should expect for that race.
Click OK to save the data.
Figure 81: Pool Configuration
- OmniSport 2000 1
- Timing Console 1
- DAKTRONICS INC 2
- Section 1: Introduction 17
- Connections 22
- Connecting to Lane Modules 22
- Connecting to the Timer 23
- Individual Lane Deck Plate 25
- Start Location Deck Plate 25
- Bulkhead Deck Plate 25
- Wall Plates 25
- Horn Start Components 26
- Always Remember 26
- Figure 37: Touchpad cart 30
- Correct Paper Installation 32
- Figure 43: Incorrect Paper 33
- 0 4 + * 40
- 4 2 0 2 2 40
- Next Event 43
- Lengths 44
- Figure 49: Keypad Navigation 45
- ▪ ← OK OK E OK 46
- Start of Race 47
- Split Times 47
- Finish Times 47
- Timer Reset 47
- Final Time 48
- Store/Print 51
- Arming Delay 52
- Pool Configurations 52
- Swimming Printouts 53
- In Lane and In Place Order 53
- Relay Exchange 54
- Printout 54
- Splits Printouts 54
- Figure 59: Stored Race tab 55
- Figure 60: Right 55
- From SCBD ON/OFF Menu 58
- From SCBD 2-DIMMING Menu 59
- From Main Menu [↓] 59
- From Main Menu – [2]>[↓] 60
- From Main Menu-[3] 62
- From Main Menu-[3]>[1] 63
- From Main Menu – [4] 64
- From Main Menu – [4]>[1] 64
- N.O. and N.C 66
- From Main Menu – [4]>[5] 74
- Software 77
- Registering 78
- Serial Port 79
- New Event Order 80
- Event Data 82
- Main Application Screen Tabs 83
- Stored Races 83
- Scoreboard 84
- Console Printer 87
- Pro Printer 87
- Results 90
- Comm Ports 90
- Before the meet 91
- Set Up Event Order 92
- Before a Race 92
- Verify Console Settings 92
- Verify the Lengths 92
- During a Race 93
- Lane Status 93
- After a Race 94
- Judges’ Score Keys 96
- Round Key 97
- Diver Key 97
- Current Total 97
- Select Order 97
- A/S, B/P, C/T and D/F Keys 97
- Print Key 98
- Score Abort and Edit 98
- Configure Number of Judges 100
- Selecting the Order 100
- Entering Scores 100
- ED13584 102
- From Main Menu – [1]>[2] 103
- From Main Menu – [1]>[3] 103
- to change the 105
- From Main Menu – [2>[5] 107
- From Main Menu – [2>[6] 107
- From Main Menu – [3] 108
- From Main Menu – [3]>[1] 108
- Figure 96: Settings Printout 109
- [Enter] to save 111
- From Main Menu – [5]>[3] 115
- Section 8: Judge Consoles 117
- Online Registration 122
- Manual Registration 123
- Splash Screen Features 124
- Splash Screen Tasks 124
- Set up Events 125
- - Set up Judges 125
- Figure 107: Creating Rosters 125
- Run Reports 126
- Select a Meet 126
- Printouts 126
- Figure 109: Com Port 127
- Display Configuration 128
- Current Diver 129
- Next Diver 129
- Judge Scores 129
- Diver Statistics 130
- Event Order 130
- Making Divers Active 130
- Adding/Removing Divers 130
- Editing Scores 131
- Editing Diver Information 131
- Editing Dive List 131
- Editing Dives 131
- Rearranging Divers 131
- Cutting/Uncutting Divers 132
- Ranking 132
- Manage Meets 132
- In Meet 135
- Dive Order 135
- Scoring 135
- Leaderboard 135
- Reports 136
- Event Results 136
- Options 137
- DD Tables 137
- Rosters 137
- OmniSport Console 138
- Display 138
- DD Table 139
- Color Scheme 140
- Keyboard Shortcuts 143
- Swimming Software 145
- Synchronization with Timer 147
- Figure 152: Event Routine 148
- Figure 166: Rank Tab 152
- Figure 167: Roster Tab 152
- Figure 168: Affiliation Tab 152
- Timer Configuration 153
- Setup Configurations 153
- General Configurations 154
- Com Settings Configurations 154
- Protocol List Configurations 154
- Monitor Data Flow 154
- Before the Meet 155
- Verify the Configurations 155
- Test the System 155
- During an Event 155
- After an Event 156
- Water Polo 157
- Auto Horn▪ 158
- Manual Horn 158
- Game Time Keys 158
- Set Time▪ 158
- Delete Penalty▪ 161
- Clear All Penalties▪ 161
- Settings to Note 161
- Period Keys 162
- Time Out ON/OFF 162
- From Main Menu – [1] 163
- From Main Menu – [1]>[1] 163
- From Main Menu – [2] 164
- From Main Menu – [2]>[1] 164
- From Main Menu – [2]>[2] 164
- From Main Menu – [3]>[2] 167
- From Main Menu – [3]>[3] 168
- From Main Menu-[3]>[4] 169
- From Main Menu-[3]>[5] 170
- From Main Menu-[4] 170
- From Main Menu-[4]>[1] 170
- 3-PACE CLOCK 173
- The Keypad 173
- SELECT SPORT 173
- From Main Menu [2]>[1] 176
- Before Securing the RTOP 183
- Attach and Connect the RTOP 184
- Test the RTOP 185
- Single-line Scoreboards 189
- Multi-line Scoreboards 189
- Store Print 191
- Paper Feed 191
- Event Heat 191
- Place/Lane/Non-Lane Timing 192
- Disqualification (DQ) 192
- Printer Setup 193
- Verify the Console is Reset 193
- Start Operations 193
- Check for Unused Lanes 193
- Watch Lane Status LCDs 193
- Always Ready Start 194
- USE MISSED START: 194
- 02:23:14.50 Y/N 194
- Track Configurations 195
- Results Printouts 195
- Settings 197
- From Main Menu - [1]>[1] 198
- From Main Menu - [1]>[2] 198
- From Main Menu - [1] 198
- From Edit Menu – [2]>[1] 199
- From Main Menu-[3>[2] 201
- From Main Menu – [4]>[2] 202
- From Main Menu – [4]>[3] 205
- From Main Menu – [4]>[4] 207
- From Main Menu – [5]>[4] 209
- Return Programs 211
- Shipping Address 212
- Appendix A: Drawings 217
- LL-2549 R02 229
- SWIMMING 229
- LL-2566, REV 02 230
- SHOT TIME 231
- GAME TIME 231
- LL-2573, REV 03 232
- LL-2581, REV 01 233
- PACE CLOCK 233
- Appendix B: Quick Reference 235
- OMNISPORT 237
- PREMEET SET-UP 238
- Special Functions 239
- Typical Diving Operation 240
- 2000 TRACK QUICK REFERENCE 241
- OmniSport 245
- 2000 and Hy-Tek 245
- Registering the Software 249
- Using the Splash Screen 249
- Creating a New Meet 250
- Running A Meet 251
- Generating Reports 252
- Swimming Menu Navigation 253
- Diving Menu Navigation 254
- Water Polo Menu Navigation 255
- Pace Clock Menu Navigation 256
- Track Menu Navigation 257
- Swim.itf) 276
- in the 288
- 067 in the RTD 288
- DAKTRONICS 299
Manuais e produtos relacionados com Relógios de parede Daktronics PC-2001
(10 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.049 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais