Daktronics PC-2001 Manual do Operador descarregar pdf (Página 79)

The Standard Console Control level of registration allows the

complete use of the software except the use of the race log

files and the results printouts. The Race Log and Results

Printouts level is the full version of the software. It is not

possible to unlock only the Race Log and Results Printouts

level.

To register the software, follow these steps:

1. Start the program. Request the Registration Code

from Daktronics and enter the code in the field as

illustrated in Figure 70.

2. Click Register.

Note: If the user registers the OmniSport software on a computer, the Registration Code

pertains only to that workstation. Reloading the software on a different computer requires

a new Registration Code.

Serial Port

Once the hardware and software have been installed and the software is running, the

OmniSport 2000 Pro system should synchronize with the timer. A message box may display

requesting which configuration settings are preferred. If the message box says, Cannot Detect

Console, then the wrong COM Port is configured. To establish a proper connection:

1. Ensure the cable is connected to a COM Port on the back of the computer and to the

expansion port on the OmniSport 2000 timer.

2. Start the Pro software. Open the Configure dialog in the options menu and select the

tab that reads Com Ports, and then click [Configure] in the Interface Com Port area.

3. A dialog box appears (Figure 71) with all of the current

Com Ports. Select a port and click OK.

4. Click Monitor. If the computer is receiving data in the

top half of the monitor window, the connection was

made properly and the correct port was selected.

Data on the bottom half is the data being sent by

the Pro software.

5. If the computer is not receiving data, go back to step 3

and select a different port. Do this until data is received through the selected port.

Note: Some computers purchased with this software will have a Rocket

port installed with

the system. The port labeled Port 0 will be normally set as COM port 5 in the computer

system. The next port would then be COM 6, then COM 7, and finally COM 8 for a four-port

Rocket port. The OmniSport 2000 Pro software recognizes these ports no matter what port

number has been assigned to them.

Figure 70: Registration Dialog

Figure 71: Select Com Port

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 299 300

Sem comentários

Daktronics PC-2001 Manual do Operador Página 79