Daktronics PC-2001 Manual do Operador descarregar pdf (Página 194)

Always Ready Start

The Always Ready Start feature is based on the fact that the OmniSport 2000 timer has an

internal time-of-day clock that continually runs when the timer is turned on. The internal

clock continues to run even when the race clock has been stopped.

If a start was missed because the timer was not reset (race clock was still running from the

previous race), the start impulse is logged in the memory and on the printer. To prompt the

operator that a start has occurred, reset the timer. If the operator chooses to use the received

start signal, the timer will automatically start timing the event by calculating the correct

running time. Press [Edit] to retrieve the start impulse used for the last race.

If two independent OmniSport 2000 timers are being used in parallel for an especially critical

application and one timer misses a start impulse completely because of a technical problem, a

start time may be manually entered when read from the printout of the other timer.

Example: Editing a Start - If a start is missed because the timer was not reset before the start:

 The time-of-day of the start impulse will be logged on the printer.

 The OmniSport will inform the operator of the start after the timer is reset.

Procedure:

1. To reset the timer:

 Press [Reset], then [Enter].

 The following message displays on the screen:

 Accept the missed start by pressing [Enter] and the timer will start from the

missed start time. If the missed start is to be ignored, simply press the [Clear] key

and the timer will be reset only.

2. If the start time was not on the LCD screen, use the Edit-Start menu:

 With the timer reset, press [Edit]. This reveals the Edit-Start menu and puts the

time-of-day of the last start impulse on the LCD.

 Confirm that the time-of-day shown on the LCD is the correct time for the start of

the race. The start time may be edited using the number keys.

 Press [Enter]. This completes the editing operation. The race clock will start and

the running time will be correct based on the entered start time.

This section describes operations that must take place after an event has completed. Doing

these operations will increase the effectiveness of accurate timing and help ease the flow of

running a large track meet.

Store Print

If an error is observed on the printout, press [Edit]. Press [Store Print] to verify the

correction. After all corrections are made, press [Reset]>[Enter]. Refer to Section 15.4

The timer is now ready to begin the next event. Advance to the next event or heat and

continue. Follow the steps in Sections 14.5 and 14.6 through each race.

USE MISSED START:

02:23:14.50 Y/N

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 299 300

Sem comentários

Daktronics PC-2001 Manual do Operador Página 194