Daktronics PC-2001 Manual do Operador descarregar pdf (Página 51)

start signal, the timer will automatically start timing the event by calculating the correct

running time. If the timer has already been reset, press [Edit] to retrieve the start impulse

used for the last race.

After the race the operator saves and prints the results, makes corrections if necessary and

disqualifies a swimmer if the meet referee requests it. (Review the Edit and Disqualification

in Section 4.3.)

Store/Print

Refer to pg. 26-27 to keep the race data for later use and print the results for verification.

If an error is observed on the printout, press [Edit]. Press [Store/Print] to verify the

correction. After all corrections are made, press [Reset]>[Enter].

The timer is now ready to begin the next event. Advance to the next event or heat and

continue. Follow the steps in Sections 4.6 and 4.7 through each race.

Reading and Editing the Printout

The OmniSport 2000 printer uses the following symbols in its printouts to label data.

Symbol

Definition

Plus touch

Minus touch

B(1-3)

Buttons 1 through 3

Relay Take-Off Platform trigger

Discrepancy between touchpad and backup

B or BK

Backup time

Edited time

Manual time

Early Relay exchange

R(1-3)

Relay exchange 1 through 3

Always Ready Start

The Always Ready Start feature is based on the fact that the OmniSport 2000 timer has an

internal time-of-day clock that continually runs when the timer is turned on and even when

the race clock has been stopped. The feature is used when: the timer was not reset, a start was

missed, or the timer was accidentally reset after a valid start. Every start signal is recorded on

the race log and in the timer. It is extremely helpful to know how to reset the timer if a start

is missed because the timer was not reset. Refer to Section 4.3 to follow the steps to reset

the timer.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 299 300

Sem comentários

Daktronics PC-2001 Manual do Operador Página 51