Daktronics PC-2001 Manual do Operador descarregar pdf (Página 192)

Place/Lane/Non-Lane Timing

 Lane Timing: Pressing [Lane Timing] enables all lanes and buttons configured in the

system. When this is enabled, each lane has one to three buttons that will record

when a racer finishes the race.

 Place Timing: Pressing [Place Timing] enables all places and buttons configured in

the system. When this is enabled, each place has one to three buttons that will record

when a racer finishes the race.

 Non-Lane Timing: Pressing [Non-Lane Timing] disables all of the buttons except

Lane 1, Button 1. The official should press the button for every competitor finishing

the race.

 Non-Lane Split Enable: [Non-Lane Split Enable] uses the next button recorded to

calculate the cumulative and subtractive split for that last lap. The split time will be

printed and displayed on the scoreboard. The [Non-Lane Split Enable] key only

works if the [Non-Lane Timing] key has been pressed.

Reset

The timer is automatically reset when first turned on. The timer may be reset any time the

race clock is running by pressing [Reset]>[Enter].

When a race is complete, the operator presses [Reset]>[Enter] to reset the timer.

Note: If the operator has not pressed [Store Print] before resetting the timer, pressing [Reset]

will store the race and print the results in addition to resetting the clock.

If the timer was not reset before the start of the next race, see Section 14.6 Always Ready Start.

Press [Menu] to access additional functions and setting in the console. Section 15: describes

the menus in track mode and how to navigate them.

Disqualification (DQ)

The DQ (disqualification) flag can be used to disqualify a racer with subsequent re-ranking

on printouts and on the scoreboard.

Typical operation: Press [DQ] and [Lane On/Off] key for the desired lane or enter the lane

number on the number keypad and press [Enter]. Doing this sets the DQ flag for that lane.

The DQ operation should normally be done at the conclusion of the race, after the officials

have ruled on the situation that caused the athlete to be disqualified. On exit from the DQ

command, the scoreboard is automatically updated and any subsequent printouts will show

the revised placing. The DQ operation can be done at any point in the race and does not affect

arming or recording of times for the lane. By pressing the same lane number again while in

the DQ command, the lane is ―re-qualified‖ and the original status indicator is returned

Before the meet, the timing operator should clarify with the meet referee if he/she wants the

athletes to be disqualified on the timer. Clarification of this is important for results to be

properly ranked on the printouts and meet management software which will show as a DQ

on the scoreboard.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 299 300

Sem comentários

Daktronics PC-2001 Manual do Operador Página 192