Daktronics PC-2001 Manual do Operador descarregar pdf (Página 30)

Timing System Setup

After each meet, it is crucial to follow these basic maintenance procedures to ensure the

longevity of the timing equipment.

 Turn off the power to all equipment including the OmniSport 2000 console, HS-200

horn start, results computer, OmniSport 2000 Pro computer, matrix computer,

scoreboard, printers and any other equipment associated with the system.

 When the system is set up for an event,

touchpads should be removed from the

water and inspected every 48 hours and

allowed to dry for 6 hours. Inspect

connections and the edge protectors around

the perimeter on the face to ensure it is

secure. Look at the face and top edge for

dents. At the end of each meet, remove the

touchpads from the pool, place them onto

their storage cart (Figure 37) and store them

in a room outside of the pool environment and chemicals.

 Completely dry all equipment and place into appropriate tote or carrying cases for

storage. Coat all cleaned cabling connections with silicone grease. The silicone is

Daktronics Part# LU-1002 and is included in the maintenance kit. Place portable

cabling equipment into a storage tote. Place all equipment not permanently installed,

in a cool, dry storage space away from the pool environment and chemicals.

Recommended temperatures in storage area should range between 33°F and 90° F

(55° C and 32.2° C) with adequate fresh air circulation.

Use the brush provided in the maintenance kit to remove any corrosion from the

banana connections. After cleaning, apply silicone grease to the connectors.

Figure 37: Touchpad cart

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 299 300

Sem comentários

Daktronics PC-2001 Manual do Operador Página 30