
Operating the Console in Swimming Mode
The (R) disappears if an event is selected that is not programmed. To set the Event Order,
refer to Section 4.3.
While other race information is shown on the right
LCD, the two left LCD screens show lane status and
current length. The top line is lane status and the
bottom line is the length counter. Figure 47 shows a left
LCD screen before race data has been entered. The table
below explains the lane status symbols that may appear
on the left screens during a race. This can be changed if
using touchpads at one or both ends of the pool Refer to
Section 4.7 for more information on Near End and Far End touchpad status during a race.
Lane is turned on but unarmed
Arming delay (NN represents a number from 1-99 that is counting down to 0)
Lane armed for a split time
Lane armed for a finish time
Lane has finished the race
No lane module present or fault
An overly active input—likely a bad connection or faulty button
A faulty RTOP—replace the batteries in the RTOP
The keys permanently printed on the right side of the keypad are discussed in Section 3.2.
This section will define the keys on the sport insert for swimming, part# LL-2549, as
illustrated in Figure 48. Section 3.2 explains how to install or remove the sport insert.
The keys highlighted are grouped together and shaded by lane. Lane 1 keys line-up vertically
with Lane 1 on the LCD, Lane 2 keys with Lane 2 and on through Lane 10.
Figure 47: Left LCD Screen
Figure 48: Swimming Insert LL-2549
Comentários a estes Manuais