Daktronics PC-2001 Manual do Operador descarregar pdf (Página 28)

Timing System Setup

1. Connecting deck harness and the horn start:

Figure 29 shows a Near End deck

harness connected to J10 and the

cable from the horn start plugged

into the J12 Start Input. Remember

the ground (GND) tab on dual

banana plugs line up with the black

female connector.

2. Connecting a Daktronics numeric display:

Connect the scoreboard to J2 or J3 port as shown

in Figure 30. Make sure that the plug is fully

inserted into the jack on the console.

3. Connecting to a computer with OmniSport 2000

Pro software:

Using a straight through 9-9-pin male/female

serial cable (Daktronics part# W-1267, 6' or Radio

Shack part #27-117), connect the end with male

pins to J4 on the OmniSport 2000 console (Figure

31). Connect the end with female pins to the serial

port on the computer with the OmniSport 2000

Pro software (Figure 32). If the computer does not

have a built-in serial port, use a USB-to-serial

adaptor (Figure 33 - Daktronics part# A-1801 or

Radio Shack part #26-183). The drivers for the USB device should be found on the

CD provided with the device, or on the manufacturer‘s web site.

4. Connecting to a computer with results software

(example: Hy-Tek’s MEET MANAGER):

Using a straight through 9-9-pin male/female serial cable

(Daktronics part# W-1267 - 6 or Radio Shack part #26-183),

connect the end with male pins to J6 on the OmniSport 2000

console (Figure 31). If the cable needs to be longer than 20 ,

contact Daktronics. Connect the end with female pins to the

serial port on the computer with the results software (Figure

32). If the computer does not have a built-in serial port, use a

USB-to-serial adaptor (Figure 33- Daktronics part# A-1801 or

Radio Shack part is #26-183). The drivers for the USB device

should be found on the CD provided with the device, or on

the manufacturer‘s web site.

5. Connecting a matrix display:

Different matrix displays may require different connection

methods. A typical connection method for Venus 1500 controlled displays and some

Venus

7000 controlled displays uses a 9-pin male to ¼ stereo phono cable

(Daktronics part# A-1240-0032, 50ft). Connect the 9-pin male end to J5 on the

OmniSport 2000 console (Figure 31).Connect the male ¼ stereo phono plug into the

appropriate connector on the wall plate.

Figure 29: Lane Data and Horn Start Plugs

Figure 30: Numeric Scoreboard Plug

Figure 31: Serial Cable Connection to

Console

Figure 32: Serial Cable

Connection to Computer

Figure 33: Using a USB to

Serial Adaptor

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 299 300

Comentários a estes Manuais

Sem comentários

Daktronics PC-2001 Manual do Operador Página 28

Comentários a estes Manuais

Manuais e produtos relacionados com Relógios de parede Daktronics PC-2001