Daktronics PC-2001 Pace Clock System Manual do Utilizador

PC-2001 Pace Clock System Display Manual ED-13737 Rev 4 – 14 September 2012 201 Daktronics Drive PO Box 5128 Brookings, SD 57006-5128 Tel: 1-800

Mechanical Installation 5 Section 2: Mechanical Installation This section describes the mounting details of the PC-2001. Use this section when moun

6 Mechanical Installation 2.2 Tripod Mounting Mounting the display to a tripod requires the optional tripod mounting kit (Daktronics part number 0A

Electrical Installation 7 Section 3: Electrical Installation 3.1 Power The PC-2001 contains internal batteries for power but can receive external

8 Electrical Installation Auto Off The PC-2001 features an Auto Off function, which will automatically turn the unit off in response to two conditi

Controls & Timing Functions 9 Section 4: Controls & Timing Functions 4.1 System Setup System setup information for each of the programs i

10 Controls & Timing Functions 4.2 Program Selection The Model PC-2001 display is programmable for 11 different timing programs. The operator

Controls & Timing Functions 11 4.3 Program Operations 1. Count Up or Breakout Timer. This program counts up to the configured time and then so

12 Controls & Timing Functions 7. Shot Clock. In this program, the display shows the tens and ones of seconds on the two center digits. The dis

Controls & Timing Functions 13 MENU-SETTI NGS 1-TI ME {} ENTER TI ME 00:00 * MENU-SETTI NGS 1-I NTENSI TY {} I NTENSI TY(1-

14 Controls & Timing Functions MENU-CHANGE MODE 5-WORKOUT {} MENU-WORKOUT 1-EDI T WORKOUT EDI T STEP 1* PACE 00:00 MENU-CHAN

Controls & Timing Functions 15 MENU-WORKOUT 2-I NSERT STEP {} I NSERT @STEP 3* STOP MENU-WORKOUT 3-DELETE STEP DELETE STEP 3* STOP

16 Controls & Timing Functions MENU-CHANGE MODE 7-SHOT CLOCK {} SHOT CLOCK 35 HORN=AUTO MENU-CHANGE MODE 8-12HR T.O.D. {} 12HR TI ME

Controls & Timing Functions 17 4.5 Team Manager The Daktronics PC-2001 can interface with third-party Hy-Tek™ TEAM MANAGER with WORKOUT MANAGER

Display Maintenance 19 Section 5: Display Maintenance IMPORTANT NOTES: 1. Disconnect power before doing any repair work on the scoreboard. 2. Al

20 Display Maintenance 5.2 Replacing the Digit/Driver Printed Circuit Board 1. To access the digit/driver PCB, remove the 10 outer screws to separ

Display Maintenance 21 5.4 Schematics For advanced scoreboard troubleshooting and repair, it may be necessary to consult the schematic drawing. Dra

22 Display Maintenance 5.6 Daktronics Exchange and Repair & Return Programs Exchange Program The Daktronics Exchange Program is a quick, econom

Display Maintenance 23 Repair & Return Program For items not subject to exchange, Daktronics offers a Repair & Return Program. To send a par

ED-13737 Product 1153 Rev 4 – 14 September 2012 DAKTRONICS, INC. Copyright  2003-2012 All rights reserved.

Reference Drawings 25 Appendix A: Reference Drawings Drawing Title Drawing Number Schematic, PC-2001 and TI-2022 ...

JC-100SWIM STOPRESTLL-2584, REV 01CIRCUITPACE CLOCK

Daktronics Warranty and Limitation of Liability 27 Appendix B: Daktronics Warranty and Limitation of Liability

Copyright © Daktronics, Inc. SL-02374 Rev 10 02-Mar-2009 Page 1 of 2 DAKTRONICSWARRANTY AND LIMITATION OF LIABILITY This Warranty and Limi

Copyright © Daktronics, Inc. SL-02374 Rev 10 02-Mar-2009 Page 2 of 2 C. Damage caused by the failure to provide a continuously suitable en

Table of Contents i Table of Contents Section 1: Introduction ...

Introduction 1 Section 1: Introduction This manual explains the installation and maintenance of Daktronics Portable Pace Clock, PC-2001. For addit

2 Introduction 1.2 Resources Figure 2 illustrates a Daktronics drawing label. The drawing number is located in the lower-right corner of a drawing.

Introduction 3 1.4 Display Overview The PC-2001 is a portable timing system with 11 programmable functions. Though external power and signal can b